50
MEDEA Programming Manual
The following buttons (some are enabled only by highlighting a point of the table) are shown below:
•
Modify
: This can be used to edit the parameters of the point highlighted in the table.
•
CSV
: This can be used to export the points table to a
“.csv” file, which can be opened with a
spreadsheet.
•
: This can be used to export the point table to a PDF file.
The
<
and
>
buttons at the bottom right are used to navigate between the pages of the points (In/Out), if
their number is greater than the number that can be displayed in a single screen.
4.8.1
Balance customizations
Press the
(Advanced settings) button placed at the bottom of the table you can access the input
customisation that can be used to customise in eight different ways both the sensor wiring mode and the
resistive value of the single balancing resistors used.
Figure 43 - Balancing customisations
The list of balance customisations is displayed in table form
The following information is provided for each customisation:
•
NUMBER:
This indicates the sequential number of the customisation.
•
DESCRIPTION:
You can assign a description to the customisation.
•
CONTACT TYPE:
This indicates the type of diagram used for wiring the sensor.
Figure 44- Balancing customisations
