26
MEDEA Programming Manual
4.1.5
Advanced Setting
•
Serial BUS speed:
This can be used to set the speed of the dialogue of the devices connected on
the bus selecting the values manually.
•
Tamper alarm Auto-inibition:
This can be used to exclude the tamper alarms coming from the
BUS line after N. signalling cycles.
4.2
Optional modules
This function can be used to configure the general telephone parameters and the optional modules
mounted on the CPU board of the control panel.
To go directly to the module of interest, without manually scrolling through the submenu page, click on the
Module GSM
,
Module PSTN
,
Module ZigBee
and
Module WiFi
links located below the title.
A
Start
link that can be used to return to the top of the page appears at the end of the various modules.
4.2.1
Phone General Parameters
This can be used to configure the operating parameters that concern all types of telephone connection.
It is accessed through the
CONFIGURATION
→ Central Unit → Optional Modules
menu.
Figure 11 - General telephone parameters
The menu shows the following items and can be used to set:
•
Line Priority
: If the control panel can make the telephone call using several types of telephone
network, it sets the network to be used as priority. Mobile is the cellular telephone network, PSTN the
fixed network.
•
Call Delay (sec
: This sets the delay, in seconds, of sending the telephone alarm from when the control
panel signals an alarm. This delay can be used to cancel an alarm, triggered by mistake, before the
corresponding telephone signal is triggered. With 0 seconds the telephone alarm is immediate.
IMPORTANT!
A value other than 0 in the call delay time invalidates compliance with EN 50131.
