79
English
Caution:
Use only these handles to open the shielding panels. Do not open the shielding
panels by taking the bottom. The large lever effect thus created may cause the
panels to crack. Cracks in the shielding panels are not covered by the warranty.
• Open the panels upwards with a swing-out action as you would with a wing door.
Caution:
When opening the second panel, the fi rst panel already
opened may lower some 20 cm. Keep this in mind.
Caution:
Never move or transport the machine with shielding panels opened.
• When closing the shielding panels make sure to never let the panels come down but to
support their down movement in order to achieve smooth closing against the machine.
• Take care to ensure that the hydraulic lines do not get jammed between the frame
and the shielding panel.
• Make sure to retighten/refi t the guard lachtes after closing the shielding panels.
This ensures that the safety switch will not cause the engine to be switched off unintentionally.
P2
Removing the discharge belt conveyor
Caution:
Removing the discharge belt conveyor will expose the discharge opening of
the shredding chamber. So, always switch off the machine and remove the
key from the ignition.
• Open the two shielding panels (see § AP.A-P1).
• The machine has two quick disconnects fi tted on the left hand side to
connect the discharge belt conveyor to the hydraulic circuit. Clean the
hoses and remove all dust/dirt build ups from the quick disconnects.
(1)
• Undo the quick disconnect by sliding the knurled ring of the female
coupler backward.
• Connect the two free ends of the hydraulic quick release couplings of
(1)