27
English
• Before starting the engine, check that there is adequate oil and fuel in the engine. If necessary,
read the following sections: § 9.2 Filling up with petrol, § 12.1.1 Checking the oil level
• Remove third parties from the safety area around the machine. (See safety area on page )
Warning:
The engine must never be run in an enclosed area for a long period of time
(> 30 sec.). Exhaust gases contain toxic substances and may lead to poisoning
or suffocation.
Caution:
Never start up the machine if the cooling air suction intake is obstructed
in any way (to prevent the engine from overheating).
Caution:
Before starting up the machine, make sure to wear the ear defenders
supplied as standard.
• Verify that the shredding chamber is empty and whether the blade shaft can rotate freely. This
is to avoid starter mechanism overloading.
• Ensure the shredder hopper is empty (no garden waste, no tools, etc.).
• Verify that the discharge belt conveyor is folded upwards (read AP.A-P2) and the safety switch
pressed. If not, the machine cannot be started.
• Pull the black control handle around the feed opening fully towards you (STOP position)
(6)
.
• Move the throttle control lever
(1)
to the mid-position.
• Close the choke lever
(2)
by pulling the knob.
• Turn the ignition key
(3)
to the 1 position and make sure the red oil level pilot light
(4)
comes
on. This lets you check the pilot light for proper operation. (If this is not the case, replace the
light, part. N° BE 510 110 120 light.)
• Move the key to the 2 position; the start motor
cranks the engine and the green pilot light
(5)
of the ABM system will come on for a few
seconds.
• Release the key when the engine starts.
• Push the choke
(2)
fully home.
• Run the engine at full
throttle
(1)
.