ELGO Electronic P40-000 Series, Руководство по эксплуатации

Страница: 22 / 64

Axis Menu
- 22 -
Example: Positioning with 3 speeds
For the parameter setting generally applies:
Figure 9: Correction stop with 3 speeds
Tolerance window
If the current actual position of the target position corre/− to the value of "tolerance window",
the corresponding output "tolerance zone" (

10.3.2) is set.
Manipulation
It is possible to adjust the indicator of the actual value of the corresponding axis to the target value
within the entered tolerance window. The entered tolerance range is always active in the + and – range
around the target value. The real actual value is saved in the microprocessor, i.e. no positioning errors
will add up.
Example: Entered Value = 0.2 mm (i.e. Tolerance Window ± 0.2 mm)
Internal actual value 99.8 mm
Displayed actual value 100.0 mm
Target Value 100.0 mm
NOTE!
Before starting-up initially the tolerance window should be set to 0.
Spindle compensation
In order to adjust spindle or sprocket tolerances, the target position must always be approached from
the same direction, i.e. in one direction the target position will be overrun by the entered value. After
expiration of the time entered in parameter axis

X-/Y-axis

times

spindle compens., the axis will
move to the defined target position again.
Slow speed  Creep speed > Correction stop
100.0 mm
Position reached: 100.0 mm
Correction Stop
Creep speed
Slow speed: 20.0 mm
Creep speed: 10.0 mm
Correction stop: 1.0 mm
99.0 mm
Slow speed
90.0 mm
Slow
Fast
80.0 mm
Middle