ELGO Electronic P40-000 Series, Руководство по эксплуатации

Страница: 39 / 64

System Menu
- 39 -
10.2 System: System-Times
Next set stepping
This is the time setting in seconds (0.0 … 9.9) how long the controller should wait in the program-mode,
with auxiliary counter “auto-program” until the next set is positioned.
Clamping off
If the function „clamping off“ is assigned to an output (system

I/O-configuration

output function),
the controller is waiting between setting the output and the start of positioning, as well as between reset-
ting the output (after completion of positioning) and the release of the next action for the specified time
(0.0 … 9.9 s). This function is used to release (activate) e. g. a clamping system or brake right before (af-
ter) positioning.
Edit-mode timeout (no PIN necessary)
This is the time until exiting the input mode (0.0 … 9.9 s, default setting: 2.0 s)
Piece counter program
Here the time is defined in seconds (0.0 … 9.9), which presents the signal “quantity reached” in the pro-
gram mode. If the values = 0, the output “quantity reached is set statically.
Clamp auxiliary function
If the program mode „next program step“ has been chosen and the parameter system

setup

options

auxiliary function setting is „on“, the auxiliary function outputs are hold for the defined time (0.0 … 9.9
in seconds). After this it is switched to the next set.
Next set stepping
Clamping off
Editmode timeout
Piece counter prog
Clamp aux function
Setup
Access to the system parameters
System-Times
Access to system parameters concerning times
I/O-configuration
Here the inputs and outputs can be assigned
Default parameter
Reset the parameters to factory settings