Electronics Line infinite prime, Руководство по установке

Страница: 70 / 113

-70-
10.3.4: Home ID
The Home ID is a short message that is played at the beginning of a vocal message call in
order to identify the system to the user. For example, at the beginning of the vocal message
call, the message “Michael’s House” shall be played before the event messages.
To play back the Home ID message:
•
From the Programming menu, select Communications, Accounts,
Home ID, Play Message [95191].
To record a Home ID message:
1. From the Programming menu, select Communications, Accounts,
Home ID, Record Message [95192].
2. Press to start recording the message.
3. Record your message. The message may be up to ten seconds long.
4. Press
to stop recording; the message is automatically played back
and OK? is displayed.
5. Press to save your recording.
10.4: Remote Programming
Electronics Line 3000’s Remote Programmer (RP) software enables you to operate
and program the system from a PC either on-site or from a remote location. The
software provides a comprehensive interface to the
infinite prime control system
designed to facilitate programming.
You can connect to the control system from a PC using one of three methods:
•
Direct Call: The RP calls the site, the system picks up and RP
communication is established.
•
Callback: The RP calls the site, the system picks up then hangs
up. The system then calls the Callback telephone number to
establish a connection.
•
Serial Connection: The RP connects directly via the Main board’s USB port
(this method requires that you install the optional Serial Interface board).
The following programming options relate to the method in which the Remote
Programmer software connects with the system.
10.4.1: Callback Telephone Number
RP Callback is a security feature that helps ensure that remote programming is only
performed by authorized personnel. When the Remote Programmer contacts the control
system, the control system hangs up and calls the Callback telephone number.
To edit the Callback telephone number:
1. From the Programming menu, select Communications, Remote Prog.,
Call-Back # [9521].
2. Enter up to 16 digits. Use the key to enter “*”, “#”, “,” (pause), “T”
(switch to DTMF tone dialing), “P” (switch to pulse dialing) or “+”
(international code). Use the key to delete one character at a time.
3. Press when you have finished editing.
,
If there is no Callback telephone number programmed, RP Callback is disabled and the
system connects to the Remote Programmer software using the “direct call” method.