Electronics Line infinite prime, Руководство по установке, Страница: 38 / 113

-38-
To make a Telecontrol call:
1. Call the control system either using the double call method (PSTN) or
directly (Cellular); when the control system picks up, two DTMF tones
are sounded.
2. Enter the Telecontrol code (Code 29) on your telephone within 15 seconds.
,
Do not enter your user code until you hear the two DTMF tones. Any digits entered before
the tones are sounded are disregarded by the system.
3. A DTMF tone is sounded to indicate that the system is ready to
receive commands.
The following DTMF commands are available:
•
Press " 2 " for Two-Way Audio.
o
If the TWA mode is defined as
“Simplex” ( see 10.6.12: TWA Mode ),
the audio channel opens in Listen
mode (microphone active/speaker
mute). To switch to Speak mode,
press “
1 ” on your telephone. To
switch back to Listen mode, press “ 0 ”
on your telephone.
•
Press " 3 " to fully arm the system.
•
Press " 4XX " to turn HA unit #XX ON.
•
Press "430" to activate PGM output (Unit 30)
•
Press " 5XX " to turn HA unit #XX OFF.
•
Press "530" to deactivate PGM output (Unit 30)
•
Press " 6 " to disarm the system.
•
Press " 9 " to cancel the siren.
,
The commands "3" (Full Arm),"4" (HA/PGM On), "5" (HA/PGM Off), "6" (Disarm) and "9"
(Bell Cancel) can also be executed at any time during a Two-Way Audio session.
,
Error beeps (three DTMF tones) are sounded in case of a wrong DTMF command.
,
To clear the last command, press “
@
” or “ # ”.
,
PGM Output is defined as HA Unit 30
4. The duration of the call is determined by the TC/VM Timeout ( see
10.6.11: Telecontrol/Vocal Message Timeout ). Ten seconds before the
timeout expires, two short DTMF tones are sounded. To extend the call,
press “
7 ” on your telephone. This command restarts the timeout.
5. To disconnect before the end of the timeout, press “
@
” then “ # ” on
your telephone.
5.1.5: Arm/Disarm DTMF Commands
During a Telecontrol call, you can arm and disarm the system remotely using the DTMF
commands “
3 ” (Arm) and “ 6 ” (Disarm). When arming the system in this way, the system
is armed immediately without an exit delay.