Electronics Line infinite prime, Руководство по установке, Страница: 16 / 113

-16-
4. Activate the transmitter you wish to test; the transmitter’s details appear
on the control system’s LCD. Additionally, between one and four tones
are sounded to indicate the transmitter’s signal strength. If four tones are
sounded, the transmitter is in the best possible location –
see 4.7.7:
Transmitters for further information.
5. After you have tested each transmitter, press to exit TX Test mode.
If installing with the GSM Cellular Communications module, test the GSM signal strength
using the system’s RSSI meter.
To test the GSM signal strength:
1. Press .
2. Enter your Installer code.
3. Enter
709 (Service, GSM Signal); the signal strength of the
cellular network is displayed – see 4.7.9: GSM Signal Strength for
further information.
2.2.5: Step 5 – Installing the Control system and Transmitters
Having chosen and tested the mounting location of the control system and each
transmitter, you are now ready to permanently install the system.
To permanently install the transmitters, refer to each device’s installation instructions (in
Appendix B of this manual or supplied individually with each product).
To install the control system:
1. Disconnect AC power from the control system.
2. Open the housing as explained in section
2.2.1: Step 1 – Opening
the Housing .
3. Remove the backup battery pack. If you want to install the control
system with back tamper, it is also necessary to disconnect the flat
cable connecting the Main board to the front panel keypad and remove
the Main board. Figure 2.5 shows the control system with the Main
board and the battery pack removed.
Figure 2.5: Back Cover (Main Board and Battery Pack removed)
Lower
Mounting
Hole
Lower
Mounting
Hole
Location of
Back Tamper
Screw
Upper
Mounting
Hole
Upper
Mounting
Hole