Electronics Line infinite prime, Руководство по установке

Страница: 36 / 113

-36-
Press… To…
1 Increase microphone sensitivity
4 Reduce microphone sensitivity
3 Increase speaker volume
6 Reduce speaker volume
Table 4.3: Voice Level Adjustment
4. Press ; the new settings are stored in the memory.
4.7.9: GSM Signal Strength
You can measure the GSM signal strength using the system’s RSSI (Received Signal
Strength Indication) meter. This function enables you to calculate the optimal location to
install the control system with the Cellular Communications module.
To view the GSM signal strength reading:
•
From the Service menu, select GSM Signal [709]; the signal strength
of the cellular network is displayed.
This Reading… Means…
8 to 9 The location is good
5 to 7 The location is acceptable
Less than 5 Unacceptable – choose another location!
Table 4.4: GSM Signal Strength
,
For Remote Programming over GSM, a signal strength of 7 and above is required.
4.7.10: Display Version
To display the system’s software and hardware versions.
•
From the Service menu, select Version [710]; the hardware (HW) and
software (SW) versions are displayed.
4.7.11: Enable Programming
The Enable Programming command enables a user with Master code authorization to
grant access to system programming. This feature is relevant only if the Installer Access
and/or the RP Access options are programmed as “User Initiated” –
see 9.14: Installer
Access and 10.4.4: RP Access Options .
To grant access to the installer or remote programmer:
•
From the Service menu, select Enable Prog. [711]; a 30-minute time
window is opened during which the Installer Code is valid or RP
communication may be established.
4.7.12: Global Chime
The Chime feature causes the control system’s built-in siren to ring when specific zones
are triggered. Using the Global Chime option, you can enable or disable this feature for
all zones that are defined as Chime enabled –
see 7.6.4: Chime .
To enable or disable Global Chime:
1. From the Service menu, select Global Chime [712].
2. Select either Enabled or Disabled.
3. Press
when the desired setting is displayed.
,
Though the Service menu is accessible to the Master and Installer only, Global Chime can
also be accessed via a convenient shortcut without needing to enter a valid user code. To
access the Global Chime option from Standby mode, press
then .