Electronics Line Commpact, Руководство по установке

Страница: 51 / 160

Hata! Burada görünmesini istedi ğ iniz metne Heading 1 uygulamak için Giri ş sekmesini kullan ı n. Hata! Burada
görünmesini istedi ğ iniz metne Heading 1 uygulamak için Giri ş sekmesini kullan ı n.
CommPact Installation Manual
47
7.6. Repeaters
Repeaters are designed to extend the wireless range of the Control System. Up to four repeaters
may be registered to the system with a maximum of 32 transmitters associated with each receiver.
For information on registration, deletion, and descriptor editing, see p. 135.
7.7. Wireless Siren
The Control System sends alarm and arm status information to the wireless siren’s receiver. This
requires that you register the Control System to the wireless siren’s receiver.
To register the Control System to the wireless siren’s receiver:
1. Set the wireless siren’s receiver to Registration mode – refer to the siren’s installation
instructions for further information.
2. Activate the siren using the WL Siren Test feature – see p.29, 4.7.3 Wireless Siren Test.
3. Activate the siren again; the Control System is registered to the siren’s receiver.
2 ‐ way sirens must be registered to the Control System. For information on registration and deletion,
see p. 39, 7.2.1 Registering Wireless Devices, and p. 39, 7.2.2 Deleting Wireless Devices.
7.7.1. Wireless Siren Type
The Control System supports 2 ‐ way wireless sirens. For this feature to function correctly, you must
define the wireless siren type in programming.
The following options are available:

2 ‐ Way Siren – if using the EL ‐ 2626AC wireless siren.

2 ‐ Way Siren/Kpd – if using the EL ‐ 2626AC wireless siren and EL ‐ 2621 wireless
indication keypad.
To program the wireless siren type:
1. From the Programming menu, select Devices, Siren, WL Siren Type [9152].
2. Select a siren type or No WL Siren if no siren is installed.
7.7.2. Wireless Siren Delay
The Wireless Siren Delay is the period of time during which the wireless siren is not sounded after
an alarm is triggered by Normal, Follower or 24Hr zones. This feature is implemented only when
the system is not fully armed. During the Wireless Siren Delay, the Control System’s built ‐ in siren is
sounded but the alarm report is not sent until the delay has expired. This gives the user enough
time to disarm in the event that the alarm was accidentally triggered during Part or Perimeter
arming. If the user disarms the system during the Siren Delay, an alarm event is not reported to the
central station.
To program the Wireless Siren Delay time:
1. From the Programming menu, select Devices, Siren, WL Siren Delay [9153].
2. Enter a Siren Delay time (00 ‐ 63 seconds), then press ʹ√ʹ .