Edwards nEXT200200, Инструкция по эксплуатации

Страница: 66 / 100

To assign a multi
‑
drop address, send the command that follows (where the 'd' characters
represent the address):
Command ! S 8 5 0 sp d d cr
Note:
The address can be a decimal number from 1 to 98. The address number 0 is used to
disable multi
‑
drop mode. The address number 99 is reserved as a wild card and is used in
the query set up detailed later.
The reply will be as follows:
Reply * S 8 5 0 sp r cr
The multi
‑
drop address is stored in the pump.
To check if the pump has a multi-drop address, send the command that follows:
Reply ? S 8 5 0 cr
If the reply is as follows, the pump has multi
‑
drop mode disabled:
Reply = S 8 5 0 sp 0 cr
If the pump has a multi
‑
drop address, there will be no reply. Communicate with the
pump in multi
‑
drop message protocol. Refer to Multi-drop operation on page 50 for
more information about multi
‑
drop mode and multi
‑
drop message protocol.
To check the multi-drop address of the pump, send the query as follows (using wild card
address 99 which means 'any' node):
Command # 9 9 : 9 9 ? S 8 5 0 cr
The reply will be as follows, where dd shows the multi
‑
drop address of the pump:
Reply # 9 9 : 9 9 = S 8 5 0 sp d d cr
Multi
‑
drop mode can be disabled by assigning the pump an address 0. To do this, send
the command that follows (where dd shows the multi
‑
drop address of the pump and xx
shows the address of the node that is sending the command):
Command # d d : x x ! S 8 5 0 sp 0 cr
The reply will be as follows:
Reply # x x : d d * S 8 5 0 sp 0 cr
When the multi
‑
drop mode is disabled, the pump will not respond to multi
‑
drop
commands.
5.2 Configuring the nEXT pump using a TIC
The pump can be configured using the manufacturer's TIC Turbo and Instrument
Controller or TIC Turbo Controller. Refer to Connect the logic interface to the TIC on page
38 .
The parameters of the pump that can be set using the TIC are:
▪ Power limit setting
Page 62
B85200880_D - Configuration