Eco Heating Systems CB 105 HW, Инструкция по установке, обслуживанию и эксплуатации

Страница: 134 / 147

E93.1803.901 HW 135
23
USER’S PART
This section is written for the user
Eco Heating Systems is not accountable for any damage caused by incorrect following these instructions.
For service and repair purposes use only original Eco Heating Systems spare parts.
All documentation produced by the manufacturer is subject to copyright law.
Abbreviations.
CB = Condensing Boiler
HW = Hot Water Boiler for Hot Water (drinking water) usage only.
CH = Central Heating (for central heating purposes and/or indirect hot water)
BCU = burner control unit
PB = display board/ control panel (Pixel Button)
85/105/125/155 = Model number of the water heater.
Safety guidelines
“FOR YOUR SAFETY READ BEFORE OPERATING”
“A. This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner.
Do n
ot try to light the burner by hand.”
“B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell close to the floor because
some gas is heavier than air and will settle on the floor.”
What to do if you smell gas:
▪
Don't use any electrical equipment.
▪
Don't press any switches.
▪
Close the gas supply.
▪
Ventilate the room (open the windows and/or outdoor water heater room doors).
▪
Immediately warn the installer.
“C. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been under
water.”
Without written approval of the manufacturer the internals of the water heater may not be changed. When these
changes are executed without approval, the water heater certification is invalid.
WARNING: Water temperatures over 52 °C can cause severe burns instantly from scald-
ing. The water temperature is factory set at 60 °C because of legionella prevention. Be-
fore bathing or showering always check the water temperature.
When this heater is supplying general purpose hot water requirements for use by
individuals, a thermostatically controlled mixing valve for reducing point of use water
temperature is recommended to reduce the risk of scald injury. Contact a licensed
plumber or the local plumbing authority for further information.
This water heater is equipped with a pressure switch in the event of a blocked vent the water heater will lockout.
No attempt by the user/owner should be made to put the water heater back into operation. A qualified service
technician should be notified of the issue. The water heater should only be reset by a qualified service technician
after they have diagnosed and corrected the issue that caused the safety lockout of the water heater.
Eco Heating Systems recommends the installation of a carbon monoxide detector in the water heater room for all
installations.
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause property damage or
personal injury. Installation and service must be performed by a qualified installer or service agency (who must
read and follow the supplied instructions before installing, servicing, or removing this water heater).