ECKELMANN VS 3010 BS, Инструкция по эксплуатации, Страница: 11 / 178

KGL Operating Manual – VS 3010 BS 2018-07-02 / 11 178
1.
2.
Before connecting the device, it must be checked whether the power supply is suitable for the device.
When using uncoded plug connectors, it is possible to connect them so that there is a danger to life and
limb! If this cannot be ruled out, coded plug connectors must be used.
Specified environmental conditions (e.g. humidity and temperature limits) must be observed and
complied with. Otherwise, malfunctions are possible (see chapter
Technical Data VS 3010 BS / SIOX,
). page 175
Before switching on the device, check correct wiring of the connections.
The device must never be operated without its case. Before opening the case, the device must be
disconnected from the power supply.
Note the maximum load of the relay contacts (see chapter
Technical Data VS 3010 BS / SIOX, page 175
).
Contact the supplier in the case of any malfunction.
According to experience, transmission of alarms is not yet functional during commissioning (no
telephone line laid etc.). It is strongly recommended in such cases to monitor the controller via
the CAN bus using a system centre or an operator terminal and to enable transmission of
alarms using a GSM modem via a mobile telephone system. In standalone operation, or as an
alternative to monitoring with system centre / operator terminal, an available alarm contact on
the controller must be used to realise transmission of alarms via a telephone network.
After the setting up of transmission of alarms or alarm signalling, this must be tested and
function. checked for its
For further information about the CAN bus, see the operating instruction "Basic and General Safety
and Connection Notes".
Work on the electrical system may (according only be performed by authorised specialist personnel
to the definition for specialists in DIN/VDE 0105 and IEC364, see chapter Explanation of 'safety
) and in accordance with the respective applicable instructions and hazard warnings', page 8
VDE regulations
Local safety regulations
Intended use; see chapter
Warning Signs and Symbols Used, page 8
Five safety rules according to chapter BGV A3, see Five safety rules according to BGV A3,
page 12
ESD measures, see chapter Electrostatic sensitive components and control components (ESD)
. , page 13
Operating instructions
1.4.1 Exclusion of liability for non-observance
This operating manual contains information about the commissioning, function, operation and maintenance of
the controller and the associated components.