For more information visit ebbe-america.com
a
b
1
.Apply thinset to the subfloor.
2
.Place mortar over fresh thinset.
3
.Screed mortar to desired slope and let cure.
<If using a pre-fabricated shower slope follow all manufacturer’s directions>
1
.Install Debris Plugs
2
.Caulk all joints and prepare for surface applied waterproofing membrane.
3
.Apply
waterproofing up walls/framing a minimum of 5". Follow all waterproofing manufacturer's recommendations.
After installing the wall tile backer, waterproof the entire shower with a fluid applied or sheet waterproofing
membrane per manufacturers recommendations. Water test the shower floor for several hours. Install desired
trim, and begin tile installation.
d
1
.Coat all faces of wall tile backer up min of 5" with liquid waterproofing to prevent wicking.
2
.Apply a generous
bead of sealant at the floor/wall transition.
3
. Embed the coated tile backer into the sealant and secure to the
wall.
4
. Apply sealant at the corner of the previously installed tile backer before installing the next piece.
CREATE SLOPE AND WATERPROOF SHOWER
After the INNI is installed, create a slope towards the drain, install the tile backer and
waterproof the shower assembly.
c
!
If the INNI is installed In-
Shadow, you will need to
Install the In-Shadow Trim
before installing the wall tile.
2
3
13
1
2
3
1
2
3
1
4
