8
Drill First, Then Countersink for Screws
1. Use the Drill Guide and Drill Bit
to create holes at the four corners of the Drain Body. The
drilled holes must align precisely with the pilot holes in the End Sweep.
2. Use the Countersink Guide to recess the holes for the Screw heads. The Countersink Guide limits
countersink depth and ensures the Screws will be flush with the Drain Body.
a
2. Attach Left and Right End Sweeps
Seat Drill Guide into
the corner of the Drain
Body. Holes Must Be
Accurately Located.
Prepare to Attach the End Sweep to the Drain Body:
1. Pour ABS cement into the Squeeze Bottle and apply two lines of ABS cement to the End
Sweep as shown below. Use sufficient cement to allow a small amount of "squeeze out."
2.
Use Cotton Swabs to remove excess cement at inner drain seam.
b
IMPORTANT: Apply two lines of ABS cement as shown to provide for air escape during assembly.
If air is trapped by improper application, it can create a pathway for water escape.
!
Remove excess
cement from here.
1
2
1
2
