17
IN-SHADOW INSTALLATION DETAILS
•
Using In-Sight Trim for an At-Wall installation is optional. If Trims are used, they will widen
the Drain Channel opening and align more properly with the angled front of the Access Cover.
•
Install the wall tile so it rests on the back flange of the INNI and aligns with the back face of
the Drain Channel.
•
Use the Abrasive Cut-Off Wheel to cut the Trim to length as needed. **
•
If using urethane sealant to adhere the Trim, use intermittent beads so weep water can
escape under the Trim to the Drain Channel. Trim can also be adhered to the drain with
thinset in a continuous layer as water will be able to slowly drain through the thinset.
•
Insert supplied Foam Backer Rod into Drain Channel between the In-Sight trim and wall tile. In
certain circumstances, it is better to use pieces of the Backer Rod to wedge between the wall
tile and Trim so it stays firmly in place.
•
Install floor tile. Remove Backer Rod after tile and grout have cured.
** PLEASE NOTE: When cutting Trim to desired length it is best practice to place all cut edges
at the outer ends of line drain. This will allow factory edges to butt together when using
multiple Trim pieces.
At-Wall installation leaves the Drain Channel visible from above. The wall tile extends down
to meet the top of the drain and aligns with the back face of the Drain Channel.
Four pieces of In-Sight Trim are included with E6100-25, E6100-38, E6100-50 kits.
AT-WALL INSTALLATION DETAILS
SLOPE
TILE FLUSH WITH
DRAIN CHANNEL
IN-SIGHT TRIM
FOAM BACKER ROD
¼ X 1” Foam Spacer
(included)
