Installation Instructions for
Aluminum Framed Panel Mount
Swing Up Rest Benches
1.
Measure out from the back wall of the run a distance of 1’-8 3/8” and make a mark on the
Division Panel (or side wall). Then measure up vertically a height of 1 3/4” plus the height of
the rest bench (example: If you have a 6-3/4” high rest bench you would measure up 8-1/2”).
Make a mark on the panel or side wall. Using a level, transfer the last mark you made to the
rear of the division panel. Do this on both sides of the run. See Figure 1.
1'-8 3/8"
1 3/4" + Restbench
Height
Mark through
both holes
Level Line
Trench Drain
Figure 1.
2.
Hold a support bracket so that the rear edge of the bracket is 1 7/16” from the back of the run.
(Note: on back to back runs the bracket will be against the edge of the aluminum that frames
the back edge of the division panel) Hold the top of the bracket even with the mark. Mark the
wall for drilling through both holes in the bracket. See Figure 2.
1−7/16"
1−7/16"
Building
Wall
Back
Panel
Figure 2.
Page 1 of
4
F
orm # 50 Rev. F
