![background image](http://html1.mh-extra.com/html/eaton/roadranger-trsm4106/roadranger-trsm4106_service-manual_2353178084.webp)
5/01
4/49
29. If removed, install a new oil seal to correct
depth into the speedo housing using the special
tool. Press the seal firmly down to the shoulder
ensuring the seal is not damaged.
30. Apply flange sealer Loctite 5900 and install the
speedo housing. Note the position of the longer
capscrews. Tighten the capscrew to the correct
torque (35 to 39 Nm).
Caution:
It may be necessary to install the speedo
pinion into the housing prior to this stage.
31. Apply a light grease to the oil seal lips and
install the drive flange. Do not hammer the
flange/yoke onto the shaft or the bearing spacer
may be dislodged from its location on the shaft.
This could cause damage to the spacer, bearing or
shaft and/or seriously affect mainshaft end float.
32. Fit and tighten the flange/yoke retaining locknut
to the correct torque using a flange/yoke holding
wrench. (Torque: 490 to 588 Nm.)
33. If not already installed install the sender unit or
speedo drive pinion and housing using a new seal-
ing washer. Tighten to the correct torque (20 to 27
Nm).
28. Install the speedo drive gear or rotor onto the
mainshaft against the spacer.
Содержание Roadranger TRSM4106
