![background image](http://html1.mh-extra.com/html/eaton/roadranger-trsm4106/roadranger-trsm4106_service-manual_2353178038.webp)
5/01
4/3
Disassembly of Transmission Case
Caution:
Drain gear oil from the transmission and
clean and refit the drain and filler plugs.
Note:
The transmission illustrated in this section is
a standard ratio horizontally installed unit. The pro-
cedure is the same for all transmissions but the
physical size and number of teeth on some of the
gears will vary from those illustrated on overdrive
and alternative ratio models.
Horizontally installed units have the remote control
on the side of the transmission and alternative filler
and drain plug positions.
2. Raise the transmission on a hoist and install the
unit onto the stand
3. Remove the speedometer pinion and adaptor or
electronic sender unit.
4. Remove the reverse lamp switch.
5. Using a flange/yoke holding wrench remove the
output drive flange/yoke retaining nut.
6. Remove the output drive flange/yoke, using a
suitable puller if necessary. Do not use a hammer
or the flange/yoke may be damaged.
1. Secure the adaptor plates to the transmission
case rear mounting flanges.
Note:
This may be a 4-hole square pattern on
early models.
Содержание Roadranger TRSM4106
