Eaton Powerware 9390 IAC-B, Инструкция по установке и эксплуатации

Страница: 39 / 146

Installing the IAC
3-19
EATON Powerware
®
9390 IAC-B and IAC-T Installation and Operation Manual
S
164201590 Rev C powerware.com
11. Remove the knockouts on inside panels, as required, on the bottom right-hand
side of UPM 1 and bottom left-hand side of UPM 2. Refer to the applicable
Powerware 9390 Installation and Operation manual, listed in paragraph 1.5, for the
location of the knockout plugs.
12. Remove the knockouts on the bottom left-hand and right-hand sides of the IAC
inside panel (see Drawing 164201590-5, sheet 2 of 2).
13. Install the nylon grommets from the field kit around the edges of the knockout
holes.
14. Push the IAC towards UPM 1 until the doors are flush with each other.
15. Push UPM 2 towards the IAC until the doors are flush with each other.
16. If not already installed, mount the hanger brackets to the top left side of UPM 1
and the top right side of UPM 2 using M4 screws (see Drawing 164201590-5,
sheet 2 of 2).
17. If not already installed, hang the side panels on the hanger brackets and align with
the front and rear of the UPMs.
18. If not already secured, secure the side panels at the bottom using the the M4
hex-head screws previously removed.
19. If permanently mounting the IAC and UPM 2, proceed to Step 22; otherwise,
proceed to Step 20.
20. Secure the IAC and UPM 2 in position by lowering the leveling feet until the
cabinets are not resting on the casters. Verify the cabinets are level and match the
height of the installed UPM 1 cabinet.
21. Proceed to Step 24.
22. Using the retained hardware, reinstall the shipping brackets previously removed to
the front and rear of the IAC and UPM 2 with the angle facing outward (see
Figure 3-1 on page 3-3 and Figure 3-2 on page 3-4).
23. Secure the cabinets to the floor with contractor-supplied hardware.
24. If installing a 40–80 kVA UPS with an IAC, proceed to Step 25; if installing a
100–160 kVA UPS with an IAC, proceed to Step 36.
25. Remove the left-hand screw from the top door hinge on the IAC.