Eaton Powerware 9390 IAC-B, Инструкция по установке и эксплуатации

Страница: 38 / 146

Installing the IAC
3-18
EATON Powerware
®
9390 IAC-B and IAC-T Installation and Operation Manual
S
164201590 Rev C powerware.com
UPM 1 UPM 2 IAC
Figure 3-10. Two 100–160 kVA UPMs with Line-up-and-Match IAC
3. Roll the IAC to an area near the right-hand side of UPM 1.
4. Roll UPM 2 to an area near the right-hand side of the IAC.
5. If not already open, unfasten the IAC front door latch and swing the door open.
6. If not already removed, remove the door. Remove the retaining screws located
inside the door at the top and bottom hinge pivot points, then lift the door off.
Save the retaining screws for reinstallation of the door.
7. Remove the screws securing the internal safety shield panels, and remove the
panels to gain access to the inside of the cabinet.
8. Remove the field kit from the bottom of the cabinet and retain for later use.
9. If necessary, remove the cosmetic covers and hanger brackets from the right-hand
side of UPM 1 and from the left-hand side of UPM 2. Save the covers, screws, and
brackets for later use.
10. If necessary, remove the cosmetic covers and hanger brackets from the left-hand
and right-hand side of the IAC. Save the covers, screws, and brackets for later use.