Eaton Powerware 9390 IAC-B, Инструкция по установке и эксплуатации

Страница: 41 / 146

Installing the IAC
3-21
EATON Powerware
®
9390 IAC-B and IAC-T Installation and Operation Manual
S
164201590 Rev C powerware.com
29. Secure the large nut on the IAC hinge.
30. Remove the left-hand screw from the top door hinge on UPM 2.
31. Locate a small flat bracket, four washers, and M4 screw from the field kit. Align
the holes in the small flat bracket over the hole in the top of the IAC and the door
hinge screw hole on UPM 2. Use the four washers between the bracket and the
top of the IAC to match the thickness of the hinge on the UPM. Secure the
bracket to the IAC using the M4 screw, and to the hinge on the UPM using the
screw removed in Step 30 (see Figure 3-12).
32. Locate a large angle bracket, M4 screws, and large nut from the field kit. Place one
end of the bracket over the bolt on the bottom side of the lower hinge on UPM 2,
and loosely secure the bracket to the hinge with the large nut (see Figure 3-12).
33. Align the holes in the other end of the bracket with the holes in the bottom
right-hand side of the IAC (see Figure 3-12). Secure the bracket with M4 screws
from the field kit.
Top View with Small Bracket
Front View with Large
Angle Bracket
Existing
Screw
Bracket
from Kit
M4 Screw and
Four Washers
from Kit
Nut from Kit
Existing Hinge
M4 Screws
from Kit
Bracket from Kit
UPM 2 IAC
IAC
UPM 2
Figure 3-12. IAC to 40–80 kVA UPM 2 Joining Brackets