Eaton Powerware 9390 IAC-B, Инструкция по установке и эксплуатации

Страница: 17 / 146

2-1
EATON Powerware
®
9390 IAC-B and IAC-T Installation and Operation Manual
S
164201590 Rev C powerware.com
Chapter 2 IAC Installation Plan and Unpacking
Use the following basic sequence of steps to install the Integrated Accessory Cabinet (IAC).
1. Create an installation plan for the IAC (Chapter 2).
2. Prepare your site for the IAC (Chapter 2).
3. Inspect and unpack the IAC (Chapter 2).
4. Unload and install the IAC and wire the system (Chapter 3).
5. Complete the Installation Checklist (Chapter 3).
6. Have authorized service personnel perform preliminary operational checks and
startup.
NOTE Startup and operational checks must be performed by an authorized Eaton
Customer Service Engineer, or the warranty terms specified on page W-1 become void.
This service is offered as part of the sales contract for the UPS system. Contact service in
advance (usually a two-week notice is required) to reserve a preferred startup date.
2.1 Creating an Installation Plan
Before installing the IAC, read and understand how this manual applies to the system being
installed. Use the procedures and illustrations in the following chapters to create a logical
plan for installing the system.
2.2 Preparing the Site
For the IAC to operate at peak efficiency, the installation site should meet the
environmental parameters outlined in this manual. If the IAC is to be operated at an
altitude higher than 1500m (5000 ft), contact your Eaton service representative for
important information about high altitude operation. The operating environment must
meet the weight, clearance, and environmental requirements specified in Drawing
164201590-2 on page A-6 and the size requirements specified on Drawing 164201590-8
starting on page A-63.
The IAC uses natural convection cooling to regulate internal component temperature. Air
inlets are in the front of the cabinet and outlets are in the top (see Drawing 164201590-8
starting on page A-63). Allow clearance above, below, and in front of each IAC, for proper
air circulation. See Drawing 164201590-2 on page A-6 for clearances.