![background image](http://html1.mh-extra.com/html/eaton/edr-5000/edr-5000_nstallation-operation-and-maintenance-manual_3977585550.webp)
EDR-5000
IM02602007E
Testing the trip delay:
Apply a balanced three-phase current system (nominal currents).
Switch off IA (the threshold value »
Threshold« for
»
I2 Fund.« must be below 33%).
Measure the tripping time.
The present current unbalance
»
I2 Fund.« corresponds with 1/3 of the existing phase current displayed.
Testing the threshold values
Configure minimum »
%(I2/I1)« setting (2%) and an arbitrary threshold value »Threshold« (I2 Fund.).
For testing the threshold value, a current has to be fed to phase A which is lower than three times the adjusted
threshold value »
Threshold« (I2 Fund.).
Feeding only phase A results in »
%(I2/I1) = 100%«, so the first condition »%(I2/I1) >= 2%« is always fulfilled.
Now increase the phase A current until the relay is activated.
Testing the dropout ratio of the threshold values
Having tripped the relay in the previous test, now decrease the phase A current. The dropout ratio must not be higher
than 0.97 times the threshold value.
Testing %(I2/I1)
Configure minimum threshold value »
Threshold« (I2 Fund.) (0.01 x In) and set »%(I2/I1)« greater or equal to 10%.
Apply a balanced three-phase current system (nominal currents). The measuring value of »
%(I2/I1)« should be 0%.
Now increase the phase A current. With this configuration, the threshold value »
Threshold« (I2 Fund.) should be
reached before the value »
%(I2/I1)« reaches the set »%(I2/I1)« ratio threshold.
Continue increasing the phase 1 current until the relay is activated.
www.eaton.com
550