![background image](http://html1.mh-extra.com/html/eaton/edr-5000/edr-5000_nstallation-operation-and-maintenance-manual_3977585251.webp)
EDR-5000
IM02602007E
System Module Input States
Name
Description
Assignment via
Ack LED-I
Module Input State: LEDs Acknowledgment by Digital Input.
[Device Para
/Ex Acknowledge]
Ack RO-I
Module Input State: Acknowledgment of the Relay Outputs.
[Device Para
/Ex Acknowledge]
Ack Comm-I
Module Input State: Acknowledge Communication via Digital Input.
The replica that Communication has received from the device is to
be reset.
[Device Para
/Ex Acknowledge]
PS1-I
State of the module input, respectively of the signal, that should
activate this Parameter Setting Group.
[Protection Para
/PSet-Switch]
PS2-I
State of the module input, respectively of the signal, that should
activate this Parameter Setting Group.
[Protection Para
/PSet-Switch]
PS3-I
State of the module input, respectively of the signal, that should
activate this Parameter Setting Group.
[Protection Para
/PSet-Switch]
PS4-I
State of the module input, respectively of the signal, that should
activate this Parameter Setting Group.
[Protection Para
/PSet-Switch]
Maint Mode-I
Module Input State: Arc Flash Reduction Maintenance Switch
[Service
/Maint Mode]
System Module Signals
Signal
Description
Reboot
Signal: Rebooting the device: 1=Restart initiated by power supply; 2=Restart initiated by the User;
3=Set on defaults (Super Reset); 4=Restart by the debugger; 5=Restart because of configuration
change; 6=General failure; 7=Restart initiated by System Abort (host side); 8=Restart initiated by
watchdog timeout (host side); 9=Restart initiated by System Abort (dsp side); 10=Restart initiated
by watchdog timeout (dsp side); 11=Power supply failure (short term interruption) or power supply
voltage too low; 12=illegal memory access.
Act Set
Signal: Active Parameter Set
PS 1
Signal: Parameter Set 1
PS 2
Signal: Parameter Set 2
PS 3
Signal: Parameter Set 3
PS 4
Signal: Parameter Set 4
PSS manual
Signal: Manual switch over of a Parameter Set
PSS via Comm
Signal: Parameter Set Switch via Scada. Write into this output byte the integer of the parameter
set that should become acitve (e.g. 4 => Switch onto parameter set 4).
PSS via Inp fct
Signal: Parameter Set Switch via Input Function
Min. 1 param changed
Signal: At least one parameter has been changed
www.eaton.com
251