104
3. Disassembly and Assembly
01/2018 Rev. 1
EA(B)O-6X06
36. Rotate the stand and put the transmission in the
horizontal position, with the control unit opening facing
up.
37. Install the shift actuator. Use a 27mm hex socket.
NOTE: Apply Dow Corning 780 sealant onto the plug
contact surface. Tighten to the torque of 28-32 N.m
(20-23 Lb.ft).
33. Install the speedometer sensor. Use a 27mm hex socket.
NOTE: Apply Dow Corning 780 sealant onto the
sensor contact surface. Tighten sensor to the torque
of 14-20 N.m (10-15 Lb.ft).
6961
6956
5974
34. Heat the output yoke to a temperature of 110°C to 120°C
and position the yoke over the mainshaft rear spline.
Using a proper tubular device and a hammer, drive the
yoke onto the shaft.
35. Using a 24mm hex socket, install the yoke retaining bolt
and washer.
Use the tool EEA-17503 (transmission model with an
output yoke) or the tool EEA-17504 with tool EEA-17503
(transmission model with an output flange) to block the
mainshaft in order to tighten the bolt.
NOTE: Apply Dow Corning 780 sealant onto the
washer and bolt contact surfaces. Tighten bolt to the
torque of 109-122 N.m (80-90 Lb.ft).
6382
6384
Transmission Assembly
