111
EA(B)O-6X06
01/2018 Rev. 1
3. Disassembly and Assembly
End Play Adjustment
6359
6429
6. Using the tool EEA-17404 or two levers supported on
the transmission case as shown and applying the force
under the washer, push the mainshaft upward at once.
Read the mainshaft end play in the dial indicator.
7. If the mainshaft end play reading in the dial indicator is
within the specified limits, proceed with measuring the
countershaft end play or go back to the transmission
assembly and continue from the point where the
assembly was stopped. Otherwise, determine the shim
pack thickness needed to adjust the mainshaft end play
before proceeding.
8. If necessary to remove or add shims to adjust the
mainshaft end play, refer to “Rear Case, Disassembly
and Assembly” in this manual for instructions on how to
remove and install the mainshaft rear bearing cup.
1. If not removed, remove now the PTO cover.
Countershaft
NOTE:
• End play should be measured with the transmission shifted into the 1st speed.
• Countershaft end play = 0.025 a 0.100 mm (0.001 a 0.004 in)
