Eagle ICA-D212-725, Инструкция по эксплуатации

Страница: 196 / 729

ICA-D212-725 (28)
Page 47 of 48
CHAPTER 28 – FUEL SYSTEM (28-00-00)

COPYRIGHT

2007 BY DART AEROSPACE LTD.

THIS DOCUMENT IS PRIVATE AND CONFIDENTIAL AND IS SUPPLIED ON THE EXPRESS CONDITION THAT IT IS NOT TO BE USED FOR ANY PURPOSE OR COPIED OR COMMUNICATED TO ANY
OTHER PERSON WITHOUT WRITTEN PERMISSION FROM DART AEROSPACE LTD.
Revision: 6
Date: 13.08.26
28.29.1.6 Remove nut (9) and washer (8).
28.29.1.7 Remove pressure transmitter (4). If
applicable, remove plug (2) and packing (3).
Discard packing.
28.29.1.8 Cover openings with caps and/or
plugs (C-428).
29.29.1.9 If required, remove screw (5) and
washers (6) to detach bracket (7) from aft cabin
bulkhead.
28.29.2 Installation
MATERIALS REQUIRED
NUMBER NOMENCLATURE
C-008 Petrolatum
28.29.2.1 If removed, install screws (5, Figure
28-15) and washers (6) to attach bracket (7) to aft
cabin bulkhead.
28.29.2.2 If applicable, apply petrolatum (C-008)
to packing (3).
28.29.2.3 Remove protective caps and/or plugs.
If applicable, install plug (2) and packing (3).
28.29.2.4 Position pressure transmitter (4) on
bracket (7). Install washer (8) and packing (9).
28.29.2.5 Apply petrolatum (C-008) to packing
(10). Install packing and union (11).
28.29.2.6
Connect tube (12).
28.29.2.7
Connect electrical connector (1).
28.29.2.8
Perform fuel system pressure test.
28.29.2.9
Service fuel system (Chapter 12)
28.29.2.10 Perform operational check (Chapter
96)
28.29.2.11 Check area for leaks.
28.29.2.12 Close Engine cowling.
28.30 GOVERNOR BLEED LINE CHECK
VALVE
28.30.1 Removal
MATERIALS REQUIRED
NUMBER NOMENCLATURE
C-428 Caps and/or Plugs
28.30.1.1 De-fuel system until fuel level in aft cells
is below half full (Chapter 12).
28.30.1.2 Gain access through door on bottom of
fuselage to area aft of F.S. 178.
28.30.1.3 Using a suitable vessel to catch trapped
fuel, disconnect governor bleed tube (5, Figure 28-
12) from check valve (4) on center fuel cell access
door. Cap open line with caps and/or plugs (C-428).
28.30.1.4 Hold bushing (3) wrench while removing
check valve (4) with packing. Cover opening to
keep out contamination.
28.30.2 Installation
28.30.2.1 Uncover bushing at center cell access
door.
28.30.2.2
Remove caps and/or plugs
28.30.2.2 Install check valve (4, Figure 28-12),
with arrow pointing forward and with packing on
inner end, into bushing (3). Hold bushing with
wrench while tightening valve.
28.30.2.3 Connect governor bleed tube (5) to
check valve.
28.30.2.4 Check for leaks during next servicing
and operation of systems.