Eagle ICA-D212-725, Инструкция по эксплуатации

Страница: 13 / 729

ICA-D212-725 (01)
Page 12 of 17
CHAPTER 01 – INTRODUCTION (01-00-00)

COPYRIGHT

2007 BY DART AEROSPACE LTD

THIS DOCUMENT IS PRIVATE AND CONFIDENTIAL AND IS SUPPLIED ON THE EXPRESS CONDITION THAT IT IS NOT TO BE USED FOR ANY PURPOSE OR COPIED
OR COMMUNICATED TO ANY OTHER PERSON WITHOUT WRITTEN PERMISSION FROM DART AEROSPACE LTD.
Revision:
6
Date: 13.08.26
apply to the Honeywell T5317 series engines do apply. As part of the modification all applicable ADs
have been addressed. If confusion regarding applicability exist when new Bell 212, 205, or Honeywell
T5317 series ADs are issued the operator/maintainer should contact Eagle Copters for clarification.
Owner/operators of aircraft incorporating this STC will be notified of Airworthiness Directives that may
apply to their helicopter because of this STC but may not appear on the Transport Canada website
because of their airframe applicability. Owners/operators of aircraft modified per SH07-28/SR02831NY
should also consult ADR-D212-725-1 and SBR-D212-725-1 at www.dartaero.com.
1.2.4 Consumable
Materials
WARNING
HANDLING AND STORAGE OF CONSUMABLE MATERIALS SHALL BE IN ACCORDANCE WITH
MANUFACTURERS INSTRUCTIONS UNLESS OTHERWISE NOTED IN APPLICABLE MAINTENANCE
TASKS.
Consumable materials required while performing maintenance are listed in the text by name and an item
number such as “solvent (C-304)”. The number refers to item 304 in Chapter 13 of BHT-ALL-SPM,
Standard Practices Manual. In addition, a list of all consumable materials (by item number and full
nomenclature) required for each individual Chapter may be provided following the Table of Contents for
that Chapter.
Occasionally, materials used in maintenance change properties, suppliers, or are discontinued. Also, new
and more advanced materials become available. In the event of conflict between this manual and the
Standard Practices manual, the manual with the latest date of issue list the preferred material. However,
either material may be used for the accomplishment of the prescribed task unless specifically stated
otherwise.
1.2.5 Special
Tools
Certain maintenance procedures require the use of special tools. Special tools required are listed at the
beginning of the applicable maintenance paragraph. A complete description and illustration of these tools
is provided in BHT-TOOL-IPC.
1.2.6 Torques
Torques are specified as either standard or special within this manual. Standard torque values for
various type fasteners will be found in BHT-ALL-SPM. Where applicable, special torques are specified
within the text (or on illustrations) within this manual.