Eagle ICA-D212-725, Инструкция по эксплуатации

Страница: 698 / 729

ICA-D212-725 (96)
Page 87 of 90
CHAPTER 96 – ELECTRICAL SYSTEM (96-00-00)

COPYRIGHT

2007 BY DART AEROSPACE LTD.

THIS DOCUMENT IS PRIVATE AND CONFIDENTIAL AND IS SUPPLIED ON THE EXPRESS CONDITION THAT IT IS NOT TO BE USED FOR ANY PURPOSE OR COPIED OR COMMUNICATED TO ANY
OTHER PERSON WITHOUT WRITTEN PERMISSION FROM DART AEROSPACE LTD.
Revision:
4
Date: 11.06.01
96.12.11 Operational Check – Bleed Air
Priority Switch
96.12.11.1
Apply electrical power to helicopter
electrical system.
96.12.11.2
Set the NON-ESS BUS switch to
MANUAL.
96.12.11.3 Place SYSTEM SELECTOR
SWITCH to heater. Verify HEATER and ON light
are illuminated.
96.12.11.4 Raise collective pitch lever to
approximately half way up. Verify ON light
extinguishes and OFF light illuminates.
96.12.11.5
Lower collective pitch lever to full
down and verify that OFF light extinguishes and
ON light illuminates.
96.12.11.6
Set SYSTEM SELECTOR SWITCH
to OFF and verify both the HEATER and the ON
light extinguish.
96.12.11.7
Turn electrical power off.
96.12.12 Vent Blower
A right and left vent blower is provided. Electrical
circuit includes two 28 VDC blower motors, a
control switch, and VENT BLOWER circuit
breaker. Both blowers are energized with HEAT
VENT BLWR switch on the overhead console.
96.12.13 Operational Check – Vent Blower
96.12.13.1
Apply electrical power to helicopter
electrical system.
96.12.13.2
Set the NON ESS BUS switch to
MANUAL.
96.12.13.3
Set HEAT VENT BLWR switch to
ON. Verify left and right vent blowers operate.
96.12.13.4
Set HEAT VENT BLWR switch to
OFF. Verify left and right vent blowers cease to
operate.
96.12.13.5
Turn electrical power off.
Figure 96-10. Bleed Air Priority Switch