Eagle ICA-D212-725, Инструкция по эксплуатации

Страница: 606 / 729

ICA-D212-725 (95)
Page
15 of 20
CHAPTER 95 – INSTRUMENT SYSTEM (95-00-00)

COPYRIGHT

2007 BY DART AEROSPACE LTD.

THIS DOCUMENT IS PRIVATE AND CONFIDENTIAL AND IS SUPPLIED ON THE EXPRESS CONDITION THAT IT IS NOT TO BE USED FOR ANY PURPOSE OR COPIED OR COMMUNICATED TO ANY
OTHER PERSON WITHOUT WRITTEN PERMISSION FROM DART AEROSPACE LTD.
Revision:
4
Date: 11.06.01
Figure 95-4. Pitot-Static System
95.2.3 Inspection – Pitot-Static System
95.2.3.1
Inspect pitot tube for clogged or
obstructed inlet opening.
95.2.3.2
Inspect pitot tube for clogged drain
hole on bottom of tube.
95.2.3.3 Inspect pitot and static lines for leaks
and chafing.
95.2.3.4
Visually inspect pitot and static lines,
accessories and instruments of the pitot static
system and replace defective components.
95.3 STATIC SYSTEM
95.3.1
Drain Instructions – Static System
95.3.1.1 Disconnect
static lines from airspeed,
altimeter and vertical speed indicators. Cap
openings in indicators.
95.3.1.2
Blow static lines clean with dry,
filtered compressed air.
95.3.1.3
Uncap openings in indicators and
reconnect lines.
95.4 PITOT TUBE
95.4.1
Removal – Pitot Tube
95.4.1.1
Ensure all electrical power is OFF
95.4.1.2
Disconnect pitot line from tubing in
upper nose compartment.
95.4.1.3 Remove screws and lockwashers
attaching pitot tube to support and carefully pull
tube from support until electrical connector is
exposed. Disconnect electrical connector.
NOTE
Ensure adequate slack in electric
wire before pulling pitot tube.
95.4.2 Installation – Pitot Tube
95.4.2.1
Remove caps or covers from pitot
lines.
95.4.2.2
Remove caps from ends of electrical
connector attached to pitot head and connect
electrical connector while guiding pitot line and
electrical wire through the pitot support. Carefully
align pitot tube in the support.
95.4.2.3 Install attaching screws and
lockwashers attaching pitot tube to pitot support.