Eagle ICA-D212-725, Инструкция по эксплуатации

Страница: 111 / 729

ICA-D212-725 (12)
Page 16 of 24
CHAPTER 12 – SERVICING (12-00-00)

COPYRIGHT

2007 BY DART AEROSPACE LTD.

THIS DOCUMENT IS PRIVATE AND CONFIDENTIAL AND IS SUPPLIED ON THE EXPRESS CONDITION THAT IT IS NOT TO BE USED FOR ANY PURPOSE OR COPIED OR COMMUNICATED TO ANY
OTHER PERSON WITHOUT WRITTEN PERMISSION FROM DART AEROSPACE LTD.
Revision:
6
Date: 13.08.26
SEPARATION OF THE LUBRICATION OIL
FROM THE THICKENING AGENT, OIL MAY BE
REMIXED THOROUGHLY WITH THE
THICKENING AGENT TO RESTORE THE
ORIGINAL LOAD CARRYING CAPABILITIES. IF
THERE IS A LOSS OF LUBRICATING OIL FROM
THE THICKENING AGENT, DISCARD THE
ENTIRE CONTENTS OF THE GREASE
DISPENSING EQUIPMENT AND REPLACE
WITH A SUITABLE SUPPLY OF APPROVED
LUBRICANT (IL GEN-03-93).
CAUTION
DO NOT USE HIGH CAPACITY/HIGH VELOCITY
GREASE GUNS ON THE COMPONENTS. THE
USE OF HIGH CAPACITY/HIGH VELOCITY
GREASE GUNS CAN RESULT IN DAMAGE.
If it becomes necessary to change the brand of
grease, remove the old grease by purging until
only new grease is present, except as otherwise
specified.
NOTE
Prior to and following grease lubrication, visually
examine grease fittings for presence of the spring
loaded steel ball. If the steel ball is not visible,
does not spring back to the closed position, the
grease fitting indicates excessive leakage, or it is
difficult to inject grease during lubrication, replace
the grease fitting (BHT-ALL-SPM, Chapter 8). If
the grease fitting is removed due to the spring
loaded steel ball not being visible, insert a small
steel probe into the back of the grease fitting to
confirm the presence of the steel ball. If it is
identified that the steel ball is not present in the
grease fitting, further investigation is required to
ensure that the steel ball has not migrated into the
component and caused damage. Discard grease
fittings that have been removed.
12.21 LUBRICATION SYMBOLS
DELETED
12.22 LUBRICATION - LUBRICANT
RESTRICTIONS (204-040-755-005)
MATERIALS REQUIRED
Refer to BHT-ALL-SPM for specification and
source.
NUMBER NOMENCLATURE
C-015 Lubricant
204-040-755-005
(Tube Pack)
WARNING
LUBRICANT MAY CAUSE EYE AND SKIN
IRRITATION. AVOID CONTACT WITH EYES,
SKIN AND CLOTHING. WASH THOROUGHLY
AFTER HANDLING.
NOTE
Do not exceed lubrication intervals specified on
lubrication chart.
CAUTION
LUBRICANT IN ORIGINAL TUBES AND
COMPONENTS CONTAINING LUBRICANT 204-
040-755-005 (TUBE PACK) (C-015) MUST BE
STORED AT MODERATE AMBIENT
TEMPERATURES, PERFERABLY LESS THAN
80°F (26.7°C). ELEVATED STORAGE
TEMERATURES PROMOTE OIL SEPERATION
FROM THE LUBRICANT.
12.22.1
Lubricant 204-040-755-005 (tube pack)
(C-015) shelf life is 4 years from packing date on
container.
NOTE
Make sure grease is thoroughly mixed prior to use.
12.22.2
In-stock components which utilize 204-
040-755-005 lubricant must be pulled from stock
and re-lubricated upon expiration of the original 4-
year shelf life of the lubricant.
12.22.3
Once a component lubricated with 204-