Dynapac PL2000S, Руководство по эксплуатации

Страница: 61 / 228

D 1
D PL2
000.
G
B
1-
168
- 10
.0
1
D Operation
1 Safety regulations
Injury or death can result whenever the engine, travel drive, milling drum, conveyor
or lifting units are engaged.
When operating the machine, therefore maintain strict compliance with the sections
of these operating instructions and the safety specifications dealing with personal
conduct.
Before starting up, ensure that no-one is working in or under the vehicle, and that no-
one is in the immediate danger area!
- Do not start up the engine and do not use any of the controls if there is a notice
specifically prohibiting their use!
Unless otherwise specified, only operate the controls when the engine is running!
- Check thoroughly before starting the machine. Ensure that the machine status and
position as well as the position of all safeguards, operating and adjustment fixtures
permit the machine to be started safely.
- Sound the horn as a warning before starting the machine.
When the drive unit is operating, never step under the vehicle. Do not stand in the
danger area of the vehicle unless absolutely necessary. Danger of death!
- While the equipment is operating, maintain a continuous check to ensure that no-
one is in danger!
- Ensure that all guards and covers are in place and have been secured properly!
- Remedy any damage detected without delay! Operation is prohibited in the event
of defects!
- Do not allow unauthorised people to travel on the machine.
- Clear all obstacles off the road surface and out of the working area!
- Always endeavour to select a position for the driver which places him/her on the
nearside, i.e. away from road traffic! Lock the control panel and driver’s seat in po-
sition.
- Maintain an adequate safety distance from overhangs, other equipment and other
danger areas!
- On uneven ground, drive carefully to prevent slipping, tilting or overturning.
Always keep the vehicle under careful control. Never attempt to load it beyond its ca-
pacity limits!