Dynapac PL2000S, Руководство по эксплуатации

Страница: 47 / 228

C 3
C PL2
000.
G
B
3-
16
-
10.
01
3 Transport on trailers
When transporting the machine on trailers, the load dimensions and weights should
be taken into account when selecting and using appropriate tractor vehicles and
transporters in accordance with the road traffic and registration authorities.
Approach ramps and tracks of the trailer should be coated with a slip-free material.
There must be sufficient possible attachment points on the trailer.
Approach ramps and trailers must be upright during loading to prevent the machine
from sliding or tilting sideways.
Always keep approach and transport areas free of contaminations, such as clay,
grease or oil.
Only drive onto the trailer and manoeuvre in working gear.
If necessary, use winches to secure the machine when driving on.
The machine should be cleaned before being loaded.
The machine should be parked and secured as follows:
Position the machine on the transporter ensuring that the transport height, width and
loaded distribution corresponds to the relevant regulations.
Activities and preventive measures:
- In order to achieve a lower transport height, the machine is evenly lowered down
to the upper section of the separated traction unit supports. When in this position,
the cutting tool tips of the milling drum are just (approx. 1 cm) above the ground and
can if necessary be gently rested on a wooden supporting if fitted.
- sliding shoe and scraper plate are raised slightly
- weather protecting sun roofs, ladders, operating equipment should be folded in or
removed.
- the front loading belt is placed on its support and if fitted, the parking brake is en-
gaged and the engine switched off.
- do not leave any insecure components on the machine or the load surface.