Dynapac PL2000S, Руководство по эксплуатации

Страница: 155 / 228

D 95
D PL2
000.
G
B
95
-168
-
1
0
.0
1
Guardrail
There is one guardrail on both the left
and right between the ladders and oper-
ator’s control stations.
The guardrails must be set up as re-
quired and once the operator’s control
station has been entered.
Each of the guardrails consists of two
outer sections (1) and two inner sections
(2).
- To adjust the guardrail, raise the outer
section (1) and after swivelling into the
retaining bracket through 90°, lower it
back, pointing in the right direction.
The diagrams shown here indicate the
different situations in which the guard-
rails should be set up. (Diagrams show
left-hand side of the machine, viewed
from outside.)
- (A) Open guardrail - to enter and exit
the operator's control station
- (B) Guardrails externally locked (driv-
er's seat and operating panel set up in
normal position)
- (C) Guardrails externally and internal-
ly locked (driver's seat and operating
panel moved beyond the outer edge of
the vehicle.)
- (D) Guardrails (externally and internal-
ly) locked at rear, front outer section
locked (driver's seat moved beyond
the outer edge of the vehicle, operat-
ing panel set up in normal position.)
- (E) Guardrails (externally and internal-
ly) locked out front, front outer section
locked (driver's seat set up in normal
position, operating panel moved be-
yond the outer edge of the vehicle.)
Danger of crushing! Do not reach into
the joint area during the folding process
as there is a risk that fingers and hands
will be crushed.
Sturzsich1,2,3,4,5.cdr
A
B
C
D
E
2
1
Direction travel