Dynapac PL2000S, Руководство по эксплуатации

Страница: 205 / 228

D 145
D PL2
000.
G
B
14
5-
16
8 -
10.
0
1
Milling with height sensors together with the transverse slope sensor
Initial position:
- The machine is lowered to the zero cutting depth position, the A/M buttons (1) of
both controllers are switched to semi-automatic mode (AUTO function lamps (2)
flashing).
- The transverse slope sensor has been activated on the appropriate side of the ma-
chine using the function key (3) of the rear side operating unit (position diode lights
up)
- The UP / DOWN buttons (4) are used to set the nominal values required (grading
depth (here -8 cm), transverse slope (here 2.6% down to the right) on the digital
controls for the corresponding sides.
- Lower machine to grading depth
Risk of tipping!
The transverse slope sensor responds after the grade sensor! To prevent accidents
on dangerous transverse slopes, never lower the machine from its upper position
when the transverse slope sensor has already been activated. Instead, lower the ma-
chine using both grade sensors in automatic mode or lower the machine evenly using
manual adjustment, with the aid of the function keys (5), (6), (7) on the rear side op-
erating unit. Continue until close to the cutting depth required (note direction of slope!)
Only then should the transverse slope sensor be activated.
Pult3new.tif/Moba2.cdr/Moba30.jpg
3
1
1
2
4
2
4
5 6 7