Dynamica Velocity 15HR, Инструкция по эксплуатации

Страница: 39 / 60

7-2
Pull the drain hose
Clamp Drain hose
Remove the cap
Cap
7. Maintenance
7.2 Defrosting
（
Velocity 15HR
）
When the rotor chamber is frosted, the cooling ability might be degraded. Defrost the
rotor chamber by performing the following procedures.
(1) Open the door of the centrifuge and turn off the POWER switch.
(2) Hold up the left side of the centrifuge a little. Then remove two clamps on the bottom
of the centrifuge and pull the drain hose.
(3) Remove the cap of the tip of the drain hose and put the drain hose in a beaker etc.
for drain.
(4) Leave centrifuge with the door open until you observe that the rotor chamber is
defrosted.
(5) After completing defrosting the rotor chamber, cap the drain hose and place the drain
hose to the original position.
NOTE
：
●
Be sure to cap the drain hose during the operation. The cooling ability degrades if
you operate this centrifuge whose drain hose is not capped.