Dynamica Velocity 15HR, Инструкция по эксплуатации

Страница: 22 / 60

4-4
4. Operation
4.1.3 Setting the running time
① Press the ▼ button or ▲ button once at the lower of the TIME display.
■ TIME display blinks which indicates that the
centrifuge is in the time input waiting mode.
② Press the ▼ button or ▲ button to
set the intended running time.
（ When pressing the button continuously,
the value of the running time changes rapidly. ）
■ When pressing the button, the value changes as follows.
▼
button
：
Hd
→
99
→
98
→‥‥ →
2
→
1
→
Hd
→
99
→
98
→‥
▲ button ： 1 → 2 → 3 → ‥‥ → 98 → 99 → Hd → 1 → 2 →‥
■ The running time you can set is from 1 to 99 minutes. The running time is
set in 1-minute intervals. (The continuous running is indicated as “Hd”.)
③ Confirm the entered setting by pressing DISP/CE button.
■
Even if neglecting to press DISP/CE button, the entered setting is
confirmed after about three seconds.
4.1.4 Setting the rotor temperature
①
Press the
▼
button or
▲
button once at the lower of the TEMP display.
■
TEMP display blinks which indicates that the
centrifuge is in the temperature input waiting mode.
②
Press the
▼
button or
▲
button to
set the intended temperature time.
（
When pressing the button continuously,
the value of the temperature changes rapidly.
）
■
When pressing the button, the value changes as follows.
▼ button ： 40 → 39 → 38 → ‥‥ → -18 → -19 → Lo → 40 →‥
▲
button
：
Lo
→
-19
→
-18
→ ‥‥ →
39
→
40
→
Lo
→
-19
→‥
■ The temperature you can set is from Lo(-20) ℃ to 40 ℃ . The temperature is
set in 1- ℃ intervals. (Depending on the room temperature, the rotor
temperature might not reach the set temperature.)
③ Confirm the entered setting by pressing DISP/CE button.
■
Even if neglecting to press DISP/CE button, the entered setting is
confirmed after about three seconds.
NOTE
：
●
This centrifuge has two kinds of timers. One is “Normal timer mode”, and the other is
“Actual run timer mode”. When you choose “Normal timer mode”, the run time is
counted as soon as the rotor is accelerated. When you choose “Actual run timer
mode”, the run time is counted as soon as the speed of the rotor reaches the setting
speed. “Normal timer mode” has been chosen in your centrifuge by the
manufacturer. You can choose one between two (see the section 5.3).
NOTE
：
●
The following describes the condition that TIME display of a status value
indication indicates the running time by the second.
1) When the elapsed time is less than 1 minute
at the continuous running
2)When the remaining time is less than 59 seconds
A dot stays lit at the lower right of number when TIME display indicates the running
time by the second.
min
TIME
℃
TEMP
T E M P
min
TI
T I M E