Dynamica Velocity 15HR, Инструкция по эксплуатации

Страница: 31 / 60

5-3
5. Other Functions
5.3 Actual run timer
■
This centrifuge has two kinds of timers. One is normal timer and the other is actual
run timer. The time for which the rotor reaches the set speed varies depending on
rotor types or your samples. Actual run timer is effective to get stable separation of
your samples because as soon as the rotor reaches the set speed the actual run
timer works.
■
After you have chosen between the normal timer and actual run timer, this is
registered in this centrifuge even if the POWER switch is turned off. Follow the
below procedures when checking or changing the timer mode.
(1) Checking the timer mode
①
Press the
▼
button and
▲
button (under TIME display) for 0.5 seconds or longer
simultaneously (see the below). Then the setting mode is displayed and you can
hear the short electronic sound.
②
The original indication is displayed when you press any button except TIME
setting button.
Normal timer Actual run timer
(2) Changing the timer mode
①
After displaying the setting mode (see the step (1)), press the
▼
button or
▲
button (under TIME display) to display the intended timer mode.
②
The original indication is displayed when you press any button except TIME
setting button.
The setting mode is displayed by
pressing two buttons simultaneously
for 0.5 seconds or longer.
TIME TIME
TIME
NOTE
：
●
Normal timer mode is chosen in the factory.
●
You can not check and change the setting mode during operation.
●
When you choose the actual run timer, the right figure
shows the TIME display at acceleration time.
TIME