DURKOPP ADLER 610-10, Руководство по эксплуатации

Страница: 29 / 148

Operation
Operating Instructions 610-10/630-10 - 01.0 - 01/2021 27
3. Feed the thread from top to bottom through the thread
guide (8).
4. Feed the thread to the rear side of the thread guide (8) before
threading it from rear to front through the lower hole
5. Feed the thread from top to bottom through the thread guide (7)
on the looper thread tensioner element (6).
6. Feed the thread counterclockwise around the looper thread
tensioner element (6).
Important
The thread must always be fed around the appropriate ten-
sion disk in such a way that it follows the longer path from
thread guide (7) to thread guide (5).
7. Feed the thread from top to bottom through the thread advanc-
ing device (4).
8. Insert the thread through the thread guide of the thread
channel (3). Proceed by pulling the thread from the rear under
the covering plate of the thread channel.
Fig. 10: Threading the looper thread (4)
9. Remove the cover plates to the right and left of the throat plate.
10. Lift the thread bobbin case retainer (9) from its latching.
11. Turn the handwheel to position D in such a way that the thread
take-up disk (11) is adjusted accordingly.
12. Insert the thread from the right to the left through the holes (12)
of the looper thread guide.
(9) - Thread bobbin case retainer
(10) - Looper holes (11) - Thread take-up disk
(12) - Holes in looper thread guide
⑨
⑫
⑪ ⑩