DURKOPP ADLER 610-10, Руководство по эксплуатации

Страница: 118 / 148

Troubleshooting
Operating Instructions 610-10/630-10 - 01.0 - 01/2021 116
Table of software messages
Code Type Possible causes Remedial action
1000 Error Sewing motor error:
• Encoder plug
(Sub-D, 9-pin) not connected
or defective
• Encoder defective
• Check the connection of the
encoder cable and replace, if
necessary
1001 Error Sewing motor error:
• Sewing motor plug not
connected or defective
• Check the connection of the
sewing motor cable
• Test sewing motor phases
(R = 2.8
Ω
, high impedance to
PE)
• Replace the encoder
• Replace the sewing motor
• Replace the controller
1002 Error Sewing motor insulation error • Check motor phase and PE for
low-impedance connection
• Replace the encoder
• Replace the sewing motor
1004 Error Sewing motor error:
• Incorrect direction of rotation • Replace the encoder
• Check plug assignment and
change, if necessary
• Check wiring in machine distribu-
tor and change it, if necessary
• Test motor phases and check for
correct value
1005 Error Sewing motor current error:
• Sewing motor blocked
• Encoder cable not
connected or defective
• Encoder defective
• Remove the blockage
• Check the encoder cable and
replace, if necessary
• Replace the sewing motor
1006 Error Sewing motor error:
• Max. speed exceeded
• Sewing motor cable defective
• Sewing motor defective • Switch the machine off and
on again
• Replace the encoder
• Perform reset
• Replace the sewing motor
• Contact customer service
1007 Error Error in the reference run • Replace the encoder
• Eliminate stiff movement in the
machine