DURKOPP ADLER 610-10, Руководство по эксплуатации

Страница: 125 / 148

Troubleshooting
Operating Instructions 610-10/630-10 - 01.0 - 01/2021 123
2277 Error Stepper motor overload (I²T) • Remove the cause of the stiff
movement or blockage
• Replace the stepper motor
• Replace the controller
2278 Error Encoder error • Check the connection of the
encoder cable and replace,
if necessary
• Replace the controller
2279 Error Current sensor:
• Stepper motor card defective
• Controller defective • Replace the controller
2280 Error Direction of rotation • Replace the encoder
• Check plug assignment and
change, if necessary
• Check wiring in machine distribu-
tor and change it, if necessary
• Test stepper motor phases and
check for correct value
2281 Error Error in the reference run • Replace the reference switch
2282 Error Stepper motor current error • Remove the blockage
• Check the encoder cable and
replace, if necessary
• Replace the stepper motor
2283 Error Stepper motor overcurrent • Replace the sewing motor cable
• Replace the stepper motor
• Replace the controller
2284 Error Software error • Perform reset
• Performing a software update
• Contact Customer Service
2285 Error Stepper motor insulation error • Check motor phase and PE for
low-impedance connection
• Replace the encoder
• Replace the stepper motor
2286 Error Software error • Perform reset
• Performing a software update
• Contact Customer Service
Code Type Possible causes Remedial action