Duplex Jeti DS-12, Руководство пользователя

Страница: 94 / 151

computer radio control system EN
• The AND condition: The resulting value of the switch is
calculated as minimum value from both controls. If you have two
sliders, the first one has +25% and the second one has -25%, the
result returned by the logical switch will then be -25%
. (picture ) c)
• The OR Condition: The resulting value of the logical switch is
calculated as maximum value from both controls. The higher value
will be returned
(picture ) . d )
• The Multi condition: This option still emulates a 3-position
switch. The output values of the logical switch are then in range -
100%, 0% and 100%
(picture ) . b )
Example: How to enable or disable the Butterfly function using
a switch.
Many people want to have the ability to turn the Butterfly function
on and off independently from any flight mode. So here we show the
way to do that
(see picture ) . c )
Select an arbitrary switch as Control 1 . In the picture, Sj was 1.
chosen. This switch will overwrite the function of Control 2 .
As a Control 2 select a proportional unit that will operate the 2.
Butterfly function ( P2 in this example). Make sure it is evaluated
proportionally (see picture ) . e )
Control 1 and Control 2 are linked together using AND logical 3.
function. That means, if the switch Sj is deactivated, the operation of
P2 will be blocked. Otherwise, P2 will function normally.
In menu assign the newly created 4. Fine Tuning -> Butterfly
switch L1 in the standard way and try its operation.
4.
4.
Switch 1 Switch 2
The result of the operator
AND OR Multi
\ \ \ \ \
\ ] \ ] #
] \ \ ] #
] ] ] ] ]
3. Emulating a 3-Position Switch
You can use the logic function “Multi” to allow the logic switch to act
as a 3-position switch. The “Multi” logic function can combine the
output from two 2-position switches to create a logic switch with
three output conditions.
] ] ] ]
4 . Using Proportional Logical Switches
The logical switches also offer the option of a complete proportional
evaluation that could be applied to both controls. Just select an
input stick/slider, press the
F2 “Prop.” button in the same menu
(picture ) and confirm. Then edit the selection box with options e)
“X<”, “X>”, “Lin” and make sure that you select the “Lin” option
(picture c)). At this point, the logical switch starts to act as a
proportional control.
94