Duplex Jeti DS-12, Руководство пользователя

Страница: 59 / 151

computer radio control system EN
4. 4.
9.1.5 Swash mix
Here is where you set up the swashplate CCPM (=Cyclic/collective
pitch mixing) throws for Aileron, Elevator and Pitch. You can fine
tune each of these functions by changing their percentages. If
needed, you can reverse the throws by setting a negative
percentage.
If you activate the additional function of the gyro in the
active model, after leaving the Basic Properties menu it
is necessary to carry out the control assignment
(Functions Assignment) and then select the appropriate
output channel (Servo Assignment). Setting the gyro
gain itself is carried out in the "Fine Tuning-> Gyro
Setting menu”. Note:
Swash Ring
It is possible to activate the function of the cyclic limitation for a
helicopter rotor head. Activating this function causes the restriction
of servo travel in the combined full deflection of the roll and pitch
controls so that the total size of the deflection is always within the
inner area of the displayed circle. Outside the circle there is a kind of a
dead zone of the flight controls.
Editing an item " Value " affects the diameter of the displayed circle,
ie. size of the maximum allowed deflection. The setting is global for
the whole model.
9.1.6 Basic Configuration – Multicopter
Camera Gimbal
Here you can select the type of camera gimbal used. You can select:
"Off" -> no Gimbal, "base" -> 2 axis gimbal (roll, pitch) or "full" 3 Axis
Gimbal (roll, pitch, yaw).
Use Gyro (1-3)
The user can select up to three independent settings for the flight
control system. This allows you to adjust the sensitivity of each axis of
the flight controller while in flight.
Number of chassis / landing gear servos
Here, up to 4 servo functions for the chassis / landing gear servos can
be selected, allowing each servo to be connected to a separate
receiver slot.
59