Duplex Jeti DS-12, Руководство пользователя

Страница: 91 / 151

computer radio control system EN
4. 4.
Signal Loss Alarm Settings
It is possible to define a specific response from the transmitter after
one or more receivers disconnect or lose signal. The options are:
• Loss of any receiver – the alarm is activated every time any of the
receivers loses a connection. This mode is sufficient for applications
where two receivers control separate functions of the model. Both
receivers must be connected for proper function.
• Loss of receiver Rx1 – an alarm is triggered only if the primary Rx
loses connection. This mode is intended for competition pilots who
use the primary Rx in the model while the second receiver is acting as
a reference for the judges. In this mode, the receivers are
independent and you can control your model with only one receiver
connected.
• Loss of receiver Rx2 – an alarm is triggered only if the secondary Rx
loses connection. The intended use and behaviour of this mode is
similar to the previous mode.
• Loss of both receivers – an alarm is triggered after the signal from
both receivers is lost. You should use this option if you want to join
servo signals redundantly using the Enlink plug or any other central
control unit. Both receivers must be connected for proper function.
Pairing the transmitter with receivers in Double Path mode
1. Make sure that receivers are set in Normal mode, not in Clone
mode.
2. Note down which receiver is the first and which is the second
because of later easier identification. Keep the receivers switched
off.
3. Switch on the transmitter with created model, in "Advanced
properties - Wireless modes/Trainer” menu item select "Double
Path mode”.
4. Plug the BIND PLUG interconnection into EXT output of the first
receiver. Switch on the receiver. Now the receiver expects a
sequence for pairing (in case you have
Rx firmware version 3.11 and
newer, this period is limited up to 60s).
5. Press „ 3D pushbutton ” on the transmitter over "Pair primary TX
module" command. As soon as the receiver is identified, you will be
asked for confirmation – now push OK button. Switch off the receiver
and remove pairing interconnection.
6. Plug the BIND PLUG interconnection into EXT output of the
second receiver. Switch on the receiver.
7. Press „ 3D pushbutton ” on the transmitter over "Pair secondary
TX module" command. As soon as the receiver is identified, you will
be asked for confirmation – now push OK button. Switch off the
receiver and remove pairing interconnection.
8. Switch on both receivers. The connection should be established
immediately, eventually servo control is allowed.
9. Now you can specify additional parameters of the Double Path
mode so that the transmitter correctly responds to the signal loss
from any of the receivers.
91