Duplex Jeti DS-12, Руководство пользователя

Страница: 86 / 151

computer radio control system EN
4. 4.
1. Auto-Trim Function
Auto-Trim function can be activated using any assigned switch,
knob or stick. Once this function has been activated you can trim
your model using transmitter gimbals. The direction and speed of
the trim adjustment is determined by stick movement. Larger stick
movements equal a faster trim response. When the Auto-Trim
function is active, the transmitter gimbals do not change their
standard response. The transmitter is still in normal operation mode.
It is advised to use the automatic trim function only for
the maiden flight, after proper trimming is done we
recommend disabling this function. Advice:
2. Trainer Function
The Trainer function can be set so that it may be activated using any
assigned switch, knob or stick.
3. Telemetry Recording
The Telemetry recording function can be set so that it may be
activated using any assigned switch, knob or stick. The data stream is
recorded on the internal SD memory card. All data can be found in
the
“ Log ” directory of the transmitter software after connecting the
Tx to the PC via a USB port. Active data recording is indicated on the
upper edge of the main desktop screen by a blinking circle. A solid
square graphic indicates that recording is stopped.
3a. Mode
By default ( " Auto " mode), the telemetry starts recording after any
timer is activated, Start-logging switch is flipped or Start button on
the main screen is pressed. If the
"Start/Stop" mode is selected, the
status of recording is always controlled by the position of your
selected Start-logging switch.
4. Throttle Cut Setting
This safety feature is mainly for models using glow or gasoline
engines as their main source of power. Electric models can also
highly benefit from this safety feature. The Throttle Cut function can
be activated using any assigned switch, knob or stick. By editing the
“Output Value” item, the throttle output will move to the user
defined (completely off) throttle position once the assigned switch
is activated.
5. Throttle Idle Setting
This feature is used to set the idle position for your throttle and will
prevent your engine from shutting-off when you move throttle stick
to its low position. The minimum throttle setting is defined by
editing the
“ Idle Offset ” value. When this function has been
activated, the minimum throttle setting (idle point) is defined by the
offset value as a percentage. Standard throttle function is not
affected by the idle offset setting.
9.3.2 Sticks / Switches Setup
This menu contains System Stick/Switch settings and configuration.
Various functions can be activated by any Switch, Stick or Knob
position. Switch setting enables you to set the points when your
desired function/timer/telemetry can be turned ON or OFF.
1
2
3
4
(*depends on equipment)
86