Service Manual for Flexible Batch Broiler, CE Version
13
6/19/2014
SM-BR-BR-0007
CONVEYOR DRIVE MOTOR AssEMBLY
The Conveyor Drive Motor Assembly is located
in the lower front of the broiler at the discharge
end. The motor drives the Conveyor by use of a
drive chain.
WARNING
DIsCONNECT THE ELECTRICAL
POWER TO THE BROILER AND
FOLLOW LOCKOUT / TAGOUT
PROCEDUREs.
1. Remove the Conveyor Drive Motor Cover.
Refer to the COVERS and PANELS section
of the manual.
2. Disconnect wires to motor.
3. Remove Discharge Access Panel. Refer to the
COVERS and PANELS section of the manual.
4. Remove four screws securing motor to
mounting plate and remove motor.
5. Raise motor mounting plate to disengage drive
chain from motor pulley.
6. Remove sprocket from motor shaft. Sprocket
is secured to motor shaft by two set screws.
7. Reverse procedure to install a new motor.
Ensure that one of the sprocket set screws is
tightened to the flat side of the motor shaft.
NOTE:
When installing the new motor, be sure to
engage the chain on the motor sprocket. Adjust
the tension on the chain to allow 4.763 mm chain
deflection, as described in the procedure DRIVE
CHAIN DEFLECTION ADJUSTMENT in the
ADJUSTMENT Section, before tightening the
motor mounting plate screws.
COMPONENT REMOVAL
Motor
Assembly
Screws
Motor
Mounting
Plate
Conveyor Drive Motor Assembly
Chain
Motor
Sprocket
Motor sprocket and Drive Chain
