Setup (CME)
4-2
Electrical Requirements & Connection
When determining the “central mobile enclosure” location on site, consider setting up near the
electrical power supply.
Note: This applies mainly to systems not equipped with a dedicated generator.
•
The main feed wiring must be adequately sized to carry the minimum ampacity
shown on the water heater cabinet’s rating label. All electrical connections,
connectors and wire must be CSA/UL compliant and installed according to local laws
and codes.
•
Before making any electrical connections, be sure that the electric power supply is
“Off”.
Electrical Connection
•
The 600 GTS requires
115/230VAC Power. The module
is factory wired so that the only
connection to be made is a
115/230VAC service outlet.
•
The main feed wiring must be
adequately sized to carry the
minimum ampacity shown on the
water heater cabinet’s rating label.
•
All electrical connections,
connectors and wire must be
CSA/UL approved, and installed
according to local laws and codes.
•
A 4-wire hookup
figure 10
(3-1) is required for all systems to work properly.
Warranty is void if the wiring hookup is not done correctly.
Heat Transfer Fluid “HTF”
*CAUTION! At no time, should you use automobile antifreeze in your system. The use
of automobile antifreeze will void your warranty.*
•
The heat transfer fluid “HTF” level should show no more than ¼ on the gauge (cold
fluid) at start-up. As the “HTF” warms to operating temperature, fluid expansion will
raise the level to ½ or ¾ on the gauge (depending on the total volume of fluid in the
circulation system).
Figure 10-600 GTS Electrical Hookup (230VAC)
Содержание 600 GTS Series
