Setup/Operation (HR2250)
6-4
Although the torque limiter clutch is factory set at DRYAIR, periodic adjustment may be
required. It is recommended the torque setting of the clutch be checked twice per season (see
“Maintenance” section). With prolonged use, the two friction disks located on either side of the
A-plate sprocket, will eventually show wear.
•
It is important that the torque limiter clutch is adjusted properly. If the clutch slips
too easily, the spool will take too long to stop and hose will pile up on the reel. If the
clutch does not slip at all, damage will occur to the drive system.
Note: A visual check may be required to confirm whether it is the clutch that is slipping
or the motor.
See “Maintenance – Torque limiter adjustment” section of the operator’s manual for Torque
Limiter Adjustment & Run-In Procedure.
Содержание 600 GTS Series
